This section helps troubleshoot common error messages received when starting Shipley SuperSpeed Web Accelerator. Click any of the following error messages for resolution information.
Error Messages when Starting Shipley SuperSpeed Web Accelerator
-
"SlipStream Web Accelerator was unable to load the sdicore.dll library ..."
-
"Shipley SuperSpeed Web Accelerator detected another application using the HTTP listening port..."
-
"Shipley SuperSpeed Web Accelerator could not be started due to an installation or configuration problem..."
Error Messages when Starting Shipley SuperSpeed Web Accelerator
-
"Shipley SuperSpeed Web Accelerator was unable to load the sdicore.dll library ..."
A file or resource required by Shipley SuperSpeed Web Accelerator may have been deleted. Fully uninstall and then re-install Shipley SuperSpeed Web Accelerator.
If the problem persists contact your ISP.
-
"Shipley SuperSpeed Web Accelerator detected another application using the HTTP listening port..."
In the Shipley SuperSpeed Advanced Connection Settings, change the "Local Listening Port" to a different port, e.g. 5400 or 5500 or 5600, etc. Restart Shipley SuperSpeed Web Accelerator.
For instructions on changing the "Local Listening Port", click here to see the Product Guide.
If the problem persists contact your ISP.
-
"Shipley SuperSpeed Web Accelerator could not be started due to an installation or configuration problem..."
A file or resource required by Shipley SuperSpeed Web Accelerator may have been deleted. Fully uninstall and then re-install Shipley SuperSpeed Web Accelerator.
If the problem persists contact your ISP.






